#Speedtouch Default How To Change The

Speedtouch Default How To Change The

It should match your USB bus module - uhci, ohci, or ehci (prepend 'usb-' for 2.4 kernels).DefaultPassword Help us Add your device Search. You may need to make these changes in order to use your SpeedTouch router with your existing LAN configuration, or in order to change the LAN subnet at one side of a VPN tunnel.Default router IP is 10.0.0.138 (port 80) No username or password by default Remote access disabled my default On/Off push-button located on rear of unit.If youre using Linux 2.6 (eg, SuSE 9.1, Mandrake 10, Fedora Core 2), these can be safely ignored if they stop the modem from connecting on reboot, set LOADUSBCORE0 in /etc/speedtouch.conf Also check DEFAULTUSBINTERFACE in /etc/speedtouch.conf. The default IP address/password for your ADSL modem or router should be one of the following: Alcatel SpeedTouch Home/Pro 10.0.0.138 (no default password) Alcatel SpeedTouch 510/530/570 10.0.0.138 (no default password) Asus RT-N16 192.168.1.1 (default password admin) Billion BIPAC-711 CE 192.168.1.254 (default password admin)This article shows how to change the LAN IP address settings on a SpeedTouch 608 series router.

The Server Address should be set to the same as the new Router address ( 192.168.0.254 in our example) The Subnet Mask should be set to the Subnet mask of your new IP range Set the End IP address to the last DHCP assignable address of your new range (in our example 192.168.0.253) Set the Start IP Address to the first DHCP assignable address of your new range (in our example 192.168.0.64) Click the Add button at the bottom of the IP Addresses section.Click on the Edit link in the DHCP Pools section.

You will now lose connectivity to the router. Click the Apply button when complete.You will be returned to the Overview screen.Click again on Configure at the top right of the screen.You should now remove the old router address, by clicking on Delete next to the old router address (the 192.168.1.254/24 address in our example.)You should be presented with a confirmation prompt.Click on the OK button to confirm the deletion of the old IP address. The remaining settings can be left as they are.

See the Network setup section of the Knowledge Base if you need help doing this.Once complete you should re-connect to the router by navigating to the new IP address in your Web browser (in our example ). If your computer is on the local LAN and has a manually assigned IP address then you will need to reconfigure this to one in the new range. Then type: ipconfig /release and press enter, followed by ipconfig /renew and pressing enter.

Speedtouch Default Password